Instruction Manual

TANK-700 Embedded System
Page 24
Figure 3-11: Mounting Bracket Retention Screws
Step 3: Secure the brackets to the system by inserting two retention screws into each
bracket (Figure 3-11).
Step 4: Drill holes in the intended installation surface.
Step 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 6: Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.9 External Peripheral Interface Connectors
The TANK-700 has the following connectors. Detailed descriptions of the connectors can
be found in the subsections below.
 Audio
 Audio/video input connectors
 CAN-bus
 DIO
 Ethernet
 GPIO for remote control
 HDMI
 Power button
 Power input