Instruction Manual

TANK-700 Embedded System
Page 23
Step 5: Push the SO-DIMM into the socket at an angle (Figure 3-10).
Figure 3-10: SO-DIMM Installation
Step 6: Gently pull the arms of the SO-DIMM socket out and push the rear of the
SO-DIMM down (Figure 3-10).
Step 7: Release the arms on the SO-DIMM socket. They clip into place and secure the
SO-DIMM in the socket.
Step 8: Install the bracket that was previously removed in the same position it was
before.
Step 9: Reinstall the bottom panel to the TANK-700.
3.8 Mounting the System with Mounting Brackets
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
Step 1: Turn the embedded system over.
Step 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface (Figure 3-11).