Instruction Manual

TANK-700 Embedded System
Page 22
3.7 SO-DIMM Ins tallation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the TANK-700. Please make sure the purchased SO-DIMM complies
with the memory specifications of the TANK-700.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below.
Step 1: Remove the bottom panel by removing the five retention screws from the bottom
panel (Figure 3-1).
Step 2: Unplug the SATA signal and power cables connected to the TANK-700, and then
place the bottom panel on a flat surface.
Step 3: Locate the SO-DIMM socket on the motherboard (Figure 3-9).
Figure 3-9: SO-DIMM Socket
Step 4: Align the SO-DIMM with the socket. The SO-DIMM must be oriented in such a
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket (Figure 3-10).