User guide

TANK-700 Embedded System
Page 38
Pin Description Pin Description
1 DCD 6 DSR
2 RX 7 RTS
3 TX 8 CTS
4 DTR 9 RI
5 GND
Table 3-11: Serial Port Pinouts
Figure 3-30: Serial Port Pinout Location
3.9.15 SFP Fiber Connectors
The TANK-700 has two SFP fiber connectors. The locations of the connectors are shown
in
Figure 1-3. To install an SFP module, refer to Section 3.6.
3.9.16 USB Connectors
CN Label: USB
CN Type:
USB port
CN Location:
See
Figure 1-2 and Figure 1-3
CN Pinouts:
See
Table 3-12
The USB ports are for connecting USB peripheral devices to the system.
Step 1: Locate the USB connectors. The locations of the USB connectors are shown
in
Figure 1-3.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors. See
Figure 3-31.