User guide

TANK-700 Embedded System
Page 32
The power connector connects to the 10.5V~36V DC power adapter.
Figure 3-21: Power Input Connector
Pin Description Pin Description
1 +12V 3 +12V
2 GND 4 GND
Table 3-6: Power Input Pinouts
3.9.11 Remote Control Connector (For AT Power Mode Only)
CN Label: Remoter
CN Type:
2-pin terminal block
CN Location:
See
Figure 1-3
CN Pinouts:
See
Figure 3-22
The 2-pin terminal block connects to a remote control device. Users can control the
system power on/off by inputting high or low voltage into the terminal block.
 Turn off the system: 2 V ~ 5 V input
 Turn on the system: less than 0.4 V input
Figure 3-22: Remote Control Terminal Block Pinout Location