Manual

TANK-600 Embedded System
Page 23
3.8.3.1 DB-9 Serial Port Connection
Follow the steps below to connect a serial device to the DB-9 connector of the TANK-600
system.
Step 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 1.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See Figure 3-13.
Figure 3-13: DB-9 Serial Port Connection
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Ste p 0:
3.8.3.2 DB-78 Serial Port Connection (Optional)
Follow the steps below to connect a serial device to the DB-78 serial port connector of the
TANK-600 system.