Manual

TANK-600 Embedded System
Page 22
3.8.2 LAN Connection
There are two external RJ-45 LAN connectors on the TANK-600. The RJ-45 connector
enables connection to an external network. To connect a LAN cable with an RJ-45
connector, please follow the instructions below.
Step 1: Locate the RJ-45 connectors. The location of the LAN connector is shown in
Chapter 1.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the TANK-600. See Figure 3-12.
Figure 3-12: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the external interface.
3.8.3 Serial Device Connection
There are six RS-232 connectors via DB-9, two RS-232/422/485 connectors via DB-9 and
eight RS-232 connectors via DB-78 (optional) for serial device connection. Follow the
steps below to connect a serial device to the TANK-600.