Manual

TANK-600 Embedded System
Page 17
Figure 3-6: Mounting Bracket Retention Screws
Step 3: Secure the brackets to the system by inserting two retention screws into each
bracket (Figure 3-6).
Step 4: Drill holes in the intended installation surface.
Step 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 6: Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.4 AT/ATX Mode Selection
AT or ATX power mode can be used on the TANK-600. The selection is made through an
AT/ATX switch located on the bottom panel. To select AT mode or ATX mode, follow the
steps below.
Step 1: Locate the AT/ATX switch on the bottom panel (Figure 3-7).