Manual

SPCIE-5100DX PICMG 1.3 CPU Card
Page 63
Figure 4-18: Connect the LPT Device
4.7.6 SATA Drive Connection
The SPCIE-5100DX is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown in
Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See
Figure 4-19.