User guide

SAILORPC-12A Panel PC
Page iv
Table of Contents
1 INTRODUCTION.......................................................................................................... 1
1.1 OVERVIEW.................................................................................................................. 2
1.2 FEATURES................................................................................................................... 3
1.3 FRONT PANEL............................................................................................................. 3
1.4 REAR PANEL............................................................................................................... 3
1.5 CONNECTORS ............................................................................................................. 4
1.6 TECHNICAL SPECIFICATIONS ...................................................................................... 5
1.7 DIMENSIONS............................................................................................................... 7
2 UNPACKING ................................................................................................................. 8
2.1 UNPACK THE PANEL PC.............................................................................................. 9
2.2 PACKING LIST........................................................................................................... 10
3 INSTALLATION ......................................................................................................... 13
3.1 TIGHTEN THE PRESSURE RELEASE SCREW ............................................................... 14
3.2 HARD DRIVE INSTALLATION..................................................................................... 14
3.3 COMPACTFLASH® CARD INSTALLATION .................................................................. 16
3.4 JUMPER SETTINGS .................................................................................................... 17
3.4.1 Reset CMOS..................................................................................................... 17
3.4.2 AT/ATX Power Selection.................................................................................. 18
3.4.3 CF Mode Selection........................................................................................... 19
3.4.4 COM2 RS-232/422/485 Setup.......................................................................... 20
3.4.5 Panel Resolution Selection .............................................................................. 21
3.5 I/O CONNECTOR PINOUTS ........................................................................................ 23
3.5.1 LAN Connector ................................................................................................ 23
3.5.2 Serial Port Connector...................................................................................... 24
3.5.3 CAN-bus & Audio Connector .......................................................................... 25
3.5.4 USB Port Connector ........................................................................................ 25
3.5.5 Power Connector ............................................................................................. 26
3.6 MOUNTING THE SYSTEM .......................................................................................... 27
3.7 BOTTOM PANEL CONNECTORS ................................................................................. 27