User Manual

SAILORPC-12A Panel PC
Page 16
Step 3: Slide the SATA hard drive into the slot indicated below.
Figure 3–3: HDD Installation
Step 4: Fasten the screws.
Step 5: Make sure the outer seal is seated properly, then replace the cover.Step 0:
3.3 CompactFlash® Installation
This section covers the installation of the CompactFlash® card.
Step 1: Remove the back cover as shown in the hard drive installation above.
Step 2: Install the CompactFlash® card in the slot indicated below.
Figure 3–4: CompactFlash® Install
Step 3: Replace the cover and fasten the screws.