Manual

RPC-6106/6108 Rackmount LCD Workstation
CAUTION:
Carefully note the direction and orientation of the existing system fan prior to
replacement.
Step 1: Turn off and disconnect the workstation from all power sources.
Step 2: Remove the workstation from the rack in which it is installed.
Step 3: Loosen the fan filter bracket thumbscrews on the rear panel (
Figure 5-4).
Figure 5-3: System Fan Retention Thumbscrews
Step 4: Disconnect the system fan from the PSU.
Step 5: Remove the four retention screws on the fan bracket (
Figure 5-4).
Figure 5-4: System Fan Bracket Retention Screws
Step 6: Replace the new fan and reinsert the four previously removed retention screws
Page 45