Manual

RPC-6106/6108 Rackmount LCD Workstation
Step 4: Disconnect all internal and external peripheral device connections from the
PCI/ISA expansion card.
Step 5: Remove the retention screw that secures the CPU card to the slot on the rear
panel.
Step 6: Slide the expansion card out of the workstation.
Step 7: Install a new expansion card. (See Section
4.5.7)
Step 8: Insert the slot retention screw that was removed earlier.
Step 9: Reinstall the top cover of the workstation. (See Section
4.5.9)
Step 10: Reinstall the workstation into the rack. Refer to Section
4.6 for complete
mounting instructions.Step 0:
5.4 Backplane Replacement
To replace a backplane, please follow the instructions below.
Step 1: Turn off and disconnect the workstation from all power sources.
Step 2: Remove the workstation from the rack in which it is installed.
Step 3: Open the top cover of the RPC-6106/6108 Rackmount LCD Workstation. (See
Section
4.5.1)
Step 4: Disconnect and remove all CPU cards (see Section
5.2) and PCI/ISA expansion
cards (see Section
4.5.7).
Step 5: Remove the retention screws that secure the backplane to the workstation (see
Section
4.5.5).
Step 6: Remove the backplane from the chassis
Step 7: Install a new backplane into the chassis.
Step 8: Reinstall and reconnect all CPU cards (see Section
4.5.6) and PCI/ISA
expansion cards (see Section
4.5.7).
Page 42