Manual

RPC-6106/6108 Rackmount LCD Workstation
5.2 CPU Card Replacement
To replace a CPU card, please follow the instructions below.
Step 1: Turn off and disconnect the workstation from all power sources.
Step 2: Remove the workstation from the rack in which it is installed.
Step 3: Open the top cover of the RPC-6106/6108 Rackmount LCD Workstation. (See
Section
4.5.1)
Step 4: Disconnect all internal and external peripheral device connections from the CPU
card.
Step 5: Remove the retention screw that secures the CPU card to the slot on the front
panel.
Step 6: Slide the CPU card out of the workstation. Make sure the back edge of the CPU
card slides into the guide rails on the chassis.
Step 7: Install a new CPU card. (See Section
4.5.6)
Step 8: Insert the slot retention screw that was removed earlier.
Step 9: Reinstall the top cover of the workstation. (See Section
4.5.9)
Step 10: Reinstall the workstation into the rack. Refer to Section
4.6 for complete
mounting instructions.Step 0:
5.3 PCI/ISA Expansion Card Replacement
To replace a PCI/ISA expansion card, please follow the instructions below.
Step 1: Turn off and disconnect the workstation from all power sources.
Step 2: Remove the workstation from the rack in which it is installed.
Step 3: Open the top cover of the RPC-6106/6108 Rackmount LCD Workstation. (See
Section
4.5.1)
Page 41