Manual

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 58
Figure 4-30: Secure the Chassis
4.11.2 Panel/ Mounting
To mount the PPC-51xxA-G41/WIDS-51xA-G41 flat panel PC into a panel, please follow
the steps below.
NOTE:
The maximum panel thickness should be no more than 6 mm.
Step 1: Select the position on the panel to mount the PPC-51xxA-G41/WIDS-51xA-G41.
Step 2: Cut out a section of the panel that corresponds to the rear panel dimensions of
the PPC-51xxA-G41/WIDS-51xA-G41. The recommended cutout sizes are
shown below (
Figure 4-31, Figure 4-32 and Figure 4-33).