Manual

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 41
4.6 Drive Installation
The drive installation process is shown in the sections below.
4.6.1 Hard Drive Installation
To install a HDD, please follow the steps below:
Step 1: Remove the back cover (Section
4.4).
Step 2: The HDD bracket is attached to the elevated platform by four retention screws.
Remove the four retention screws from the elevated platform (
Figure 4-5).
Figure 4-5: HDD Retention Screws
Step 3: Attach the SATA connector cable to the bracket.