Manual

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 37
4.5.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers in described here. Doing so
may disable or damage the system
The following jumpers are preconfigured for the PPC-51xxA-G41/WIDS-51xA-G41. Users
should no change these jumpers.
Jumper Name Label Type
LCD voltage selection JLCD_PWR 6-pin header
Touch Screen Select JTOUCH1 4-pin header
Table 4-2: Preconfigured Jumpers
4.5.3 CF Card Setup
Jumper Label: JCF1
Jumper Type:
2-pin header
Jumper Settings:
See
Table 4-3
Jumper Location:
See
Figure 4-2
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
Table 4-3.
CF Card Setup Description
Open Slave
Closed Master Default
Table 4-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in Figure 4-2.