Owner manual
Table Of Contents
- Revision
- Copyright
- Manual Conventions
- Packing List
- Table of Contents
- List of Figures
- List of Tables
- BIOS Menus
- 1 Introduction
- 2 Specifications
- 3 Unpacking
- 4 Installation and Configuration
- 4.1 Installation Precautions
- 4.2 Preinstalled Components
- 4.3 Installation and Configuration Steps
- 4.4 Remove the Back Cover
- 4.5 Jumper Settings
- 4.6 Drive Installation
- 4.7 Mounting the System
- 4.8 External Peripheral Interface Connectors
- 5 BIOS Setup
- 5.1 Introduction
- 5.2 Main
- 5.3 Advanced
- 5.4 PCI/PnP
- 5.5 Boot
- 5.6 Security
- 5.7 Chipset
- 5.8 Exit
- 6 Software Installation
- 7 System Maintenance
- A BIOS Options
- B Terminology
- C Digital I/O Interface
- D Watchdog Timer
- E Address Mapping
- F Compatibility
- G Hazardous Materials Disclosure
- Index
PPC-5xxx-9455 Panel PC
Page 60
Figure 4-20: 19” Panel Cutout Dimensions
Step 3: Slide the PPC-5xxx-9455 through the hole until the metal frame is flush against
the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the PPC-5xxx-9455, behind the metal frame (
Figure 4-21). Refer to the
mounting kit packing list for the required number of mounting clamps.