Owner manual
Table Of Contents
- Revision
- Copyright
- Manual Conventions
- Packing List
- Table of Contents
- List of Figures
- List of Tables
- BIOS Menus
- 1 Introduction
- 2 Specifications
- 3 Unpacking
- 4 Installation and Configuration
- 4.1 Installation Precautions
- 4.2 Preinstalled Components
- 4.3 Installation and Configuration Steps
- 4.4 Remove the Back Cover
- 4.5 Jumper Settings
- 4.6 Drive Installation
- 4.7 Mounting the System
- 4.8 External Peripheral Interface Connectors
- 5 BIOS Setup
- 5.1 Introduction
- 5.2 Main
- 5.3 Advanced
- 5.4 PCI/PnP
- 5.5 Boot
- 5.6 Security
- 5.7 Chipset
- 5.8 Exit
- 6 Software Installation
- 7 System Maintenance
- A BIOS Options
- B Terminology
- C Digital I/O Interface
- D Watchdog Timer
- E Address Mapping
- F Compatibility
- G Hazardous Materials Disclosure
- Index
PPC-5xxx-9455 Panel PC
Page 47
4.5.8 Touch Screen Selection (JP7)
The touch screen selection jumper selects the type of touch screen panel connected to the
system.
JP7 DESCRIPTION
1-2 5-wire touch panel
2-3 closed 4-wire or 8-wire touch panel
Table 4-17: Touch Screen Selection
4.6 Drive Installation
The drive installation process is shown in the sections below. The installation process of
the following drives are shown.
4.6.1 Hard Drive Installation...................................................................47
4.6.2 CompactFlash
®
Installation...........................................................50
4.6.3 CD Drive Installation .....................................................................51
4.6.1 Hard Drive Installation
To install a HDD, please follow the steps below:
Step 1: Remove the back cover (Section
4.4).
Step 2: The HDD bracket is attached to the elevated platform by four retention screws.
Remove the four retention screws from the elevated platform (
Figure 4-2).