Owner manual
Table Of Contents
- Revision
- Copyright
- Manual Conventions
- Packing List
- Table of Contents
- List of Figures
- List of Tables
- BIOS Menus
- 1 Introduction
- 2 Specifications
- 3 Unpacking
- 4 Installation and Configuration
- 4.1 Installation Precautions
- 4.2 Preinstalled Components
- 4.3 Installation and Configuration Steps
- 4.4 Remove the Back Cover
- 4.5 Jumper Settings
- 4.6 Drive Installation
- 4.7 Mounting the System
- 4.8 External Peripheral Interface Connectors
- 5 BIOS Setup
- 5.1 Introduction
- 5.2 Main
- 5.3 Advanced
- 5.4 PCI/PnP
- 5.5 Boot
- 5.6 Security
- 5.7 Chipset
- 5.8 Exit
- 6 Software Installation
- 7 System Maintenance
- A BIOS Options
- B Terminology
- C Digital I/O Interface
- D Watchdog Timer
- E Address Mapping
- F Compatibility
- G Hazardous Materials Disclosure
- Index
PPC-5xxx-9455 Panel PC
Page 144
Figure 7-1: DIMM Socket Clip Locations
Step 3: Push the new DIMM module until it engages and the white plastic end clips click
into place. Make sure the end clips are fully secured after installation.
Step 0:
7.5 Elevated Platform Removal
The elevated platform supports the optical drive and the hard drive. It is not necessary to
remove the optical drive bracket or hard drive bracket to remove the elevated platform.
Step 1: Unfasten the elevated platform screws on the top panel (
Figure 7-2).
Figure 7-2: Top Panel Elevated Platform Screws