Owner manual
Table Of Contents
- Revision
- Copyright
- Manual Conventions
- Packing List
- Table of Contents
- List of Figures
- List of Tables
- BIOS Menus
- 1 Introduction
- 2 Specifications
- 3 Unpacking
- 4 Installation and Configuration
- 4.1 Installation Precautions
- 4.2 Preinstalled Components
- 4.3 Installation and Configuration Steps
- 4.4 Remove the Back Cover
- 4.5 Jumper Settings
- 4.6 Drive Installation
- 4.7 Mounting the System
- 4.8 External Peripheral Interface Connectors
- 5 BIOS Setup
- 5.1 Introduction
- 5.2 Main
- 5.3 Advanced
- 5.4 PCI/PnP
- 5.5 Boot
- 5.6 Security
- 5.7 Chipset
- 5.8 Exit
- 6 Software Installation
- 7 System Maintenance
- A BIOS Options
- B Terminology
- C Digital I/O Interface
- D Watchdog Timer
- E Address Mapping
- F Compatibility
- G Hazardous Materials Disclosure
- Index
PPC-5xxx-9455 Panel PC
Page 115
Boot Display Device
Use the Boot Display Device option to select the display device used by the system
when it boots. Configuration options are listed below.
Auto
CRT - Default
TV
LFP
CRT + LFP
Flat Panel Type [By Jumper]
Use the Flat Panel Type is set using the onboard jumper settings. The jumper settings
can be found in the Installation and Configuration chapter.
PID Current Jumper Setting [1-1024x768x24]
The PID Current Jumper Setting shows the current setting of the flat panel resolution
jumper.
Internal Graphics Mode Select [Enable, 8 MB]
Use the Internal Graphic Mode Select option to specify the amount of system memory
that can be used by the Internal graphics device.
Disable
Enable, 1 MB
1 MB of memory used by internal graphics device
Enable, 8 MB DEFAULT
8 MB of memory used by internal graphics device
Disabled
Scaling is disabled