Owner manual
Table Of Contents
- Revision
- Copyright
- Manual Conventions
- Packing List
- Table of Contents
- List of Figures
- List of Tables
- BIOS Menus
- 1 Introduction
- 2 Specifications
- 3 Unpacking
- 4 Installation and Configuration
- 4.1 Installation Precautions
- 4.2 Preinstalled Components
- 4.3 Installation and Configuration Steps
- 4.4 Remove the Back Cover
- 4.5 Jumper Settings
- 4.6 Drive Installation
- 4.7 Mounting the System
- 4.8 External Peripheral Interface Connectors
- 5 BIOS Setup
- 5.1 Introduction
- 5.2 Main
- 5.3 Advanced
- 5.4 PCI/PnP
- 5.5 Boot
- 5.6 Security
- 5.7 Chipset
- 5.8 Exit
- 6 Software Installation
- 7 System Maintenance
- A BIOS Options
- B Terminology
- C Digital I/O Interface
- D Watchdog Timer
- E Address Mapping
- F Compatibility
- G Hazardous Materials Disclosure
- Index
PPC-5xxx-9455 Panel PC
Page 83
IrDA
Serial Port 2 mode is IrDA
ASK IR
Serial Port 2 mode is ASK IR
Parallel Port Address [Disabled]
Use the Parallel Port Address option to select the parallel port base address.
Disabled
No base address is assigned to the Parallel Port
378 DEFAULT
Parallel Port I/O port address is 378
278
Parallel Port I/O port address is 278
3BC
Parallel Port I/O port address is 3BC
Parallel Port Mode [Normal]
Use the Parallel Port Mode option to select the mode the parallel port operates in.
Normal DEFAULT
The normal parallel port mode is the standard mode
for parallel port operation.
Bi-directional
Parallel port outputs are 8-bits long. Inputs are
accomplished by reading 4 of the 8 bits on the
status register.
EPP
The parallel port operates in the enhanced parallel
port mode (EPP). The EPP mode supports
bi-directional communication between the system
and the parallel port device and the transmission
rates between the two are much faster than the
Normal mode.