User Manual

PPC-51xxA-H61 Panel PC
Page 26
3.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the PPC-51xxA-H61.
Before the PPC-51xxA-H61 is installed, the jumpers must be set in accordance with the
desired configuration. The jumpers on the PPC-51xxA-H61 motherboard are listed in
7Table 3-1.
Description Label Type
COM1 Pin 9 setting J_COM_V1 6-pin header
COM2 Pin 9 setting J_COM_V2 6-pin header
COM3 Pin 9 setting J_COM_V3 6-pin header
COM4 Pin 9 setting J_COM_V4 6-pin header
COM5 Pin 9 setting J_COM_V5 6-pin header
COM5 RS-232/422/485 selection JP2 4-pin header
Table 3-1: Jumpers
3.6.1 Access the Jumpers
To access the jumpers, remove the back cover. To remove the back cover, please refer to
Section
73.5.