Instruction Manual

PPC-5152-D525 Falt-bezel Panel PC
Page 45
Figure 3-30: 2-pin Terminal Block Pinouts
The PPC-5152-D525 comes with a pluggable DC-in terminal block. To install the terminal
block into the power input connector, follow the steps below.
Step 1: Locate the 2-pin power input connector. The location of the power input
connector is shown in
6Figure 1-4.
Step 2: Insert the terminal block into the 2-pin power input connector on the external
peripheral interface.
Step 3: Secure the terminal block to the external interface by tightening the two slot
head screws. See
6Figure 3-34.
Figure 3-31: Power Input Terminal Block Installation
3.11.4 Power Input, DIN Connector
CN Label: DC IN
CN Type:
4-pin DIN connector
CN Location:
See
6Figure 1-4