Manual

PPC-37xxA-N26 Panel PC
Page 31
3.8.2 PPC-3710A-N26 HDD Installation
To install the HDD into the PPC-3710A-N26, please follow the steps below:
Step 1: Remove the back cover. See Section
3.5.
Step 2: Remove the HDD bracket from the PPC-3710A-N26. The HDD bracket is
attached on the panel PC with four retention screws inside the chassis
(
Figure 3-16). Remove the four retention screws and lift the bracket off the
panel PC.
Figure 3-16: PPC-3710A-N26 HDD Bracket Retention Screws
Step 3: Attach the hard drive in the bracket. To do this, slide the hard drive onto the
bracket until it connects with the SATA connector at the back. Fasten the four
retention screws on the sides (
Figure 3-17).