Manual

PPC-37xxA-N26 Panel PC
Page 28
Step 6: Insert into the socket at an angle. Line up the notch on the card with the notch
on the connector. Slide the PCIe Mini card into the socket at an angle of about
20º (
Figure 3-11).
Figure 3-11: PCIe Mini Card Installation
Step 7: Push down until the card clips into place. Push the other end of the card
down until it clips into place on the plastic connector (
Figure 3-11).
Step 8: Reassemble the whole system.
3.8 HDD Installation
3.8.1 PPC-3708A-N26 HDD Installation
To install the HDD into the PPC-3708A-N26, please follow the steps below:
Step 1: Remove the back cover. Refer to Section
3.5.
Step 2: Remove the HDD bracket from the PPC-3708A-N26. The HDD bracket is
attached on the PPC-3708A-N26 with four retention screws, two on the top
panel (
Figure 3-12) and two inside the chassis (Figure 3-13). Remove the four
retention screws and lift the bracket off the panel PC.