Manual

PPC-37xxA-N26 Panel PC
Page 23
Description Label Type
AT/ATX power selection JP3 2-pin header
Clear CMOS JP1 3-pin header
mSATA/PCIe Mini mode selection MSATA_SW1 2-pin header
Table 3-1: Jumpers
3.6.1 Access the Jumpers
To access the jumpers, remove the back cover. To remove the back cover, please refer to
Section
73.5.
3.6.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers described here. Doing so
may disable or damage the system
The following jumpers are preconfigured for the PPC-37xxA-N26. Users should not
change these jumpers.
Jumper Name Label Type
LVDS voltage selection JP5 3-pin header
Touchscreen type selection J_WIRE1 Switch
Table 3-2: Preconfigured Jumpers
Setting Description
Short 1-2 +3.3V LVDS (Default)
Short 2-3 +5V LVDS
Table 3-3: LVDS Voltage Selection Jumper Settings