User guide

PPC-37xxA-N26 Panel PC
Page 28
Step 7: Push down until the card clips into place. Push the other end of the card
down until it clips into place on the plastic connector (
Figure 3-10).
Step 8: Reassemble the whole system.
3.8 HDD Installation
3.8.1 PPC-3708A-N26 HDD Installation
To install the HDD into the PPC-3708A-N26, please follow the steps below:
Step 1: Remove the back cover. Refer to Section
3.5.
Step 2: Remove the HDD bracket from the PPC-3708A-N26. The HDD bracket is
attached on the PPC-3708A-N26 with four retention screws, two on the top
panel (
Figure 3-11) and two inside the chassis (Figure 3-12). Remove the four
retention screws and lift the bracket off the panel PC.
Figure 3-11: PPC-3708A-N26 HDD Bracket Retention Screws (Tope Panel)
Figure 3-12: PPC-3708A-N26 HDD Bracket Retention Screws (Inside)