Instruction Manual

PPC-37xx-N270 Panel PC
Page 40
4.10.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers in described here. Doing so
may disable or damage the system.
The following jumpers are preconfigured for the PPC-37xx-N270. Users should no change
these jumpers (
Table 4-2).
Jumper Name Label Type
LVDS voltage selection J_VLVDS1 3-pin header
LVDS2 Voltage Select J_VLVDS2 3-pin header
Panel Type and Resolution J_LCD_TYPE1 8-pin header
Table 4-2: Preconfigured Jumpers
4.10.3 AT Power Select Jumper Settings
NOTE:
The AT Power Select Jumper is the same as the ATX Enable
connector.
Jumper Label: ATXCTl1
Jumper Type:
3-pin wafer
Jumper Settings:
See
Table 4-3
Jumper Location:
See
Figure 4-15
The AT Power Select jumper specifies the systems power mode as AT or ATX. Use a
jumper cap to short pin 1 - pin 2 on the ATXCTL1 connector to enable the AT Power mode
on the system. In the ATX mode use the PS_ON- and 5VSB cable. AT Power Select
jumper settings are shown in
Table 4-3.