Instruction Manual

PPC-37xx-N270 Panel PC
Page 37
4.9 CD Drive Installation (PPC-3712A-N270 Only)
To install the CD drive into the PPC-3712A, please follow the steps below:
Step 1: Remove the back cover. See Section
4.5 above.
Step 2: Remove the CD drive bracket from the PPC-3712A-N270. To do this, remove
three retention screws, two on the side panel and one inside the panel PC
(
Figure 4-12).
Figure 4-12: PPC-3712A CD Drive Bracket
Step 3: Remove the CD drive cover bracket by removing the four retention screws
shown in
Figure 4-13.