Owner's manual

PPC-37xx-N270 Panel PC
Page 41
Figure 4-16: AT Power Select Jumper Location
4.10.4 CF Card Setup
Jumper Label: JCF1
Jumper Type:
2-pin header
Jumper Settings:
See
Table 4-4
Jumper Location:
See
Figure 4-17
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
Table 4-4.
CF Card Setup Description
Open Slave Default
Closed Master
Table 4-4: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in Figure 4-17.