Owner manual

PPC-37xx-N270 Panel PC
Page 62
Step 1: Locate the RJ-45 connectors on the bottom panel of the PPC-37xx-N270.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the bottom panel of the PPC-37xx-N270. See
Figure 4-34.
Figure 4-34: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the onboard RJ-45 connector. Step 0:
4.14.3 Serial Device Connection
The PPC-37xx-N270 has two single female DB-9 connectors on the bottom panel for a
serial device. Follow the steps below to connect a serial device to the PPC-37xx-N270
panel PC.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 2.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See
Figure 4-35.