User Manual

POC-17i/19i Series
Page 46
Step 6: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 7: Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 4-3).
Step 8: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 4-3).
Step 9: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 4-3: DDR SO-DIMM Module Installation
4.4.2 HDD Card Replacement
The POC-17i/19i Series is preinstalled with one HDD. To replace the HDD, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section
4.2.
Step 2: Turn off the power. See Section
4.3.
Step 3: Remove the HDD cover by removing the HDD cover screw.