User Manual

POC-17i/19i Series
Page 17
 Anti-static Discharge: If a user open the rear panel of the flat panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Remove the rear panel cover
Step 2: Remove the internal aluminum cover
Step 3: Configure the system jumpers
Step 4: Connect peripheral devices to the bottom panel of the flat panel PC
Step 5: Mount the flat panel PC
3.4 Removing the Rear Panel Cover
WARNING:
Over-tightening rear cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the POC-17i/19i Series internally, the rear panel cover must first be removed.
To remove the rear panel cover, please follow the steps below.
Step 1: Remove twenty-one (21) retention screws from the rear panel cover. See
Figure
3-1.