Instruction Manual

PCISA-945GSE CPU Card
Page 71
5.6.3 CF Card Setup
Jumper Label: JCF1
Jumper Type:
2-pin header
Jumper Settings:
See
Table 5-4
Jumper Location:
See
Figure 5-3
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
Table 5-4.
CF Card Setup Description
Open Slave
Closed Master
Table 5-4: CF Card Setup Jumper Settings
5.6.4 COM2 RS-232/422/485 Selection Jumper
Jumper Label: JP1
Jumper Type:
8-pin header
Jumper Settings:
See
Table 5-5
Jumper Location:
See
Figure 5-3
The RS-232/422/485 Serial Port Select jumper sets the communication protocol used by
COM3. The RS-232/422/485 Serial Port Select settings are shown in
Table 5-5.
RS-232/422/485 Description
1-2 RS-232
3-4 RS-422
5-6 RS-485
7-8 RS-485 with RTS Control
Table 5-5: COM2 RS-232/422/485 Selection Jumper Pinouts