Instruction Manual

PCISA-945GSE CPU Card
Page 66
Figure 5-1: CF Card Installation
5.5 ATX Power Control Connector
The ATX power control connector is required when using an ATX power source. To setup
the PCISA-945GSE for ATX power, follow the steps below.
Step 1: Set the ATX jumpers (there are two) as shown in
AT/ATX Power Selection in
Section
5.6.1.
Step 2: Connect the ATX control cable. Connect the ATX control cable to ATXCTL1 on
the PCISA-945GSE and to the ATX control connector on the backplane.
(
Figure 5-2)