Owner's manual

NANO-945GSE EPIC Motherboard
Page 77
AT Power Select Description
Short 1 – 2 Use AT power Default
Open Use ATX power
Table 4-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 4-4 below.
Figure 4-4: AT Power Select Jumper Location
4.5.2 CF Card Setup
Jumper Label: JCF1
Jumper Type:
2-pin header
Jumper Settings: See Table 4-3
Jumper Loc
ation: See Figure 4-5
The CF Card
Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in Table 4-3.