User's Manual

MODAT-328
Page 17
To start using the MODAT-328, the user must charge the MODAT-328 by the power
adapter. To charge the MODAT-328, please follow the steps below.
Step 1: Fold back the protective rubber flap to expose the mini-USB port.
Step 2: Connect the mini-USB plug of the USB cable to the mini-USB connector on the
left side panel of the MODAT-328 (Figure 2-1).
Figure 2-1: MODAT-328 Mini USB Port
Step 3: Connect the USB cable to the USB connector of the power adapter (Figure 2-2).
Then plug the power adapter to a power source.
OR connect the USB cable directly to a computer installed with the Windows XP
operating system (the MODAT-328 is only supported by the USB driver from the
Windows XP system).
Figure 2-2: Power Adapter USB Connector