User's Manual

MODAT-328
Page 14
2.1 Getting Started
The installation steps below should be followed in order.
Step 1: Unpack the device.
Step 2: Check that all parts are included.
Step 3: Charge the MODAT-328.
Step 4: Power up the system. Step 0:
2.2 Unpacking the Device
WARNING!
Only remove the protective plastic cover stuck to the front screen after
installation. The plastic layer protects the screen surface during the
installation process.
To unpack the MODAT-328, follow these steps:
Step 1: Cut the sealing tape. Only cut deep enough to cut the tape.
Step 2: Open the box.
Step 3: Lift out the device.
Step 4: Remove all the peripheral parts from the box. Step 0:
2.2.1 Packing List
NOTE:
If any items from the packing list are missing, please contact your
distributor immediately.