Owner manual

KINO-QM770 Mini-ITX SBC
Page 74
4.9.2 DVI Display Device Connection
The KINO-QM770 has a single female DVI-I connector on the external peripheral interface
panel. The DVI-I connector is connected to a digital display device. To connect a digital
display device to the KINO-QM770, please follow the instructions below.
Step 1: Locate the DVI-I connector. The location of the DVI-I connector is shown in
another chapter.
Step 2: Align the DVI-I connector. Align the male DVI-I connector on the digital display
device cable with the female DVI-I connector on the external peripheral
interface.
Step 3: Insert the DVI-I connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the KINO-QM770. See
Figure 4-19.
Figure 4-19: DVI Connector
Step 4: Secure the connector. Secure the DVI-I connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0: