Owner manual

KINO-QM770 Mini-ITX SBC
Page 62
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the KINO-QM770 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-QM770 are listed in
Table 4-1.
Description Label Type
AT/ATX mode selection J_ATXCTL1 3-pin header
Clear CMOS J_CMOS1 3-pin header
Clear ME RTC registers ME_RTC1 3-pin header
Display mode selection (CRT/DVI) JP1 3-pin header
Flash descriptor security override J_FLASH1 3-pin header
LVDS voltage selection J_VLVDS1 3-pin header
LVDS resolution selection J_PID1 8-pin header
PCIe channel mode selection J_PCIE1
J_PCIE2
2-pin header
Table 4-1: Jumpers