Owner's manual

KINO-QM670 Mini-ITX SBC
Page 55
Before the KINO-QM670 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-QM670 are listed in
7Table 4-1.
Description Type Label
AT/ATX Power Mode Setting 3-pin header J_ATXCTL1
Clear CMOS 3-pin header J_CMOS1
LVDS Panel Resolution 8-pin header J_PID1
LVDS Voltage Select 3-pin header J_VLVDS1
ME RTC Register 3-pin header ME_RTC1
Flash Security Override 3-pin header J_FLASH1
MPC Switch Control (Reserved) 3-pin header J_MPC1
Table 4-1: Jumpers
4.5.1 AT/ATX Power Mode Jumper Settings
Jumper Label:
J_ATXCTL1
Jumper Type:
3-pin header (1x3)
Jumper Settings:
See
Table 4-2
Jumper Location:
See
Figure 4-6
The AT Power Select jumper specifies the systems power mode as AT or ATX. AT/ATX
Power Mode jumper settings are shown in
Table 4-2.
AT Power Select Description
Short 1 - 2 Use ATX power
Short 2 – 3 Use AT power
Table 4-2: AT/ATX Power Mode Jumper Settings
The location of the AT/ATX Power Mode jumper is shown in Figure 4-6 below.