Manual

KINO-PVN-D5251/D4251/ Mini ITX SBC
Page 56
Step 2: Align the DVI-I connector. Align the male DVI-I connector on the digital display
device cable with the female DVI-I connector on the external peripheral
interface.
Step 3: Insert the DVI-I connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the KINO-PVN-D5251/D4251. See Figure 4-16.
Figure 4-16: DVI Connector
Step 4: Secure the connector. Secure the DVI-I connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.10 Software Installation
All the drivers for the KINO-PVN-D5251/D4251 are on the CD that came with the system.
To install the drivers, please follow the steps below.
Step 1: Insert the CD into a CD drive connected to the system.