User guide

Page 46
K INO-PV-D5253-D4253 Mini-ITX Motherboard
Figure 4-6: SATA Power Drive Connection
4.5.2 S ingle RS-232 Cable (w/o B racket)
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Locate the connector. The location of the RS-232 connector is shown in Chapter 3.
Insert the cable connector. Insert the connector into the serial port box header. See
Figure 4-7. A key on the front of the cable connectors ensures the connector
can only be installed in one direction.