User guide

Page 106
K INO-PV-D5253-D4253 Mini-ITX Motherboard
The recovery tool main menu window is shown as below. Press any key to reboot the
system.
Figure C-21: Press Any Key to Continue
C.3 S etup Procedure for Linux
The initial setup procedures for Linux system are mostly the same with the procedure for
Microsoft Windows. Please follow the steps below to setup recovery tool for Linux OS.
Hardware and BIOS setup. Refer to Section C.2.1.
Install Linux operating system. Make sure to install GRUB (v0.97 or earlier) MBR type
and Ext3 partition type. Leave enough space on the hard drive to create the
recover partition later.
NOTE:
If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,
the Symantec Ghost may not function properly.
While installing Linux OS, please create two partitions:
 Partition 1: /
 Partition 2: SWAP