Owner manual

KINO-HM551
Page 51
Figure 4-8: ME RTC Register Jumper Location
4.5.4 LVDS Voltage Selection
WARNING:
Incorrect voltages can destroy the LCD panel. Make sure to select a
voltage that matches the voltage required by the LCD panel.
Jumper Label: J_VLVDS1
Jumper Type:
3-pin header
Jumper Settings:
See Table 4-5
Jumper Loc
ation:
See Figure 4-9
The LCD voltage sele
ction jumper sets the voltage of the power supplied to the LCD
panel.
Setting Description
Short 1-2 Set The Voltage Level Of Panel To VCC3
Short 3-4 Set The Voltage Level Of Panel To VCC
Table 4-5: LVDS Voltage Selection Jumper Settings