Owner manual

KINO-GM45A Mini-ITX SBC
Page 61
4.8 External Peripheral Interface Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
 RJ-45 Ethernet cable connectors
 USB devices
 VGA monitors
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding KINO-GM45A external peripheral interface connector making
sure the pins are properly aligned.
4.8.1 LAN Connection (Single Connector)
There is one external RJ-45 LAN connector. The RJ-45 connectors enable connection to
an external network. To connect a LAN cable with an RJ-45 connector, please follow the
instructions below.
Step 1: Locate the RJ-45 connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the KINO-GM45A. See
5Figure 4-14.