Manual

KINO-G410 Mini-ITX Motherboard
Page 80
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
When the Remote Access option is set to Enabled, the following sub-menus appear.
 Serial port number
 Base Address, IRQ
 Serial Port Mode
 Redirection After BIOS POST
 Terminal Type
 Serial port number [COM1]
Use the Serial port number option to select the serial port used for remote access.

COM1 D
EFAULT
System is remotely accessed through COM1

COM2
System is remotely accessed through COM2

COM3
System is remotely accessed through COM3

COM4
System is remotely accessed through COM4

COM5
System is remotely accessed through COM5

COM6
System is remotely accessed through COM6
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
 Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
 Serial Port Mode [115200 8,n,1]