Owner manual

KINO-DH810
Page 57
Figure 4-10: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector.
4.5.4 Serial Device Connection
The KINO-DH810 has two single female DB-9 connectors on the external peripheral
interface panel for a serial device. Follow the steps below to connect a serial device to the
KINO-DH810.
Step 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 4-11.