Owner manual

KINO-DH810
Page 55
Figure 4-8: Audio Connector
Step 3: Check audio clarity. Check that the sound is coming through the right speakers
by adjusting the balance front to rear and left to right.
4.5.2 DVI Dis play Device Connection
The KINO-DH810 has a single female DVI connector on the external peripheral interface
panel. The DVI connector is connected to a digital display device. To connect a digital
display device to the KINO-DH810, please follow the instructions below.
Step 1: Locate the DVI connector. The location of the DVI connector is shown in
Chapter 3.
Step 2: Align the DVI connector. Align the male DVI connector on the digital display
device cable with the female DVI connector on the external peripheral interface.
Step 3: Insert the DVI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the KINO-DH810. See Figure 4-9.